************************ IMPORTANT *************************
The information below is provided as information only on how to clean a pilot light or pilot assembly. There are inherent dangers of working with gas. Please contact your local gas company or service center if you are at all uncomfortable working with gas. Casual Furniture World may not be held liable for any damages or personal injury caused by working with any gas product.
Can of Compressed air (available at office supply stores)
Spray bottle with soapy water.
All Knobs Should be in the OFF position
Turn Gas Valve Off
Make sure that the logs are cool, that the pilot light is off and the valve is in the off position before beginning.
INCORRECT – Shutoff Valve is in the ON positionCORRECT – Shutoff Valve is in the OFF position
Turn Off Gas Shutoff Valve
You must also turn the gas off at the gas shutoff valve. This is usually a red or yellow valve located in the back of the firebox or just outside of the fireplace.
Pilot with no Piezo lighterPilot with Piez/Spark ignition
Remove Logs and Locate Pilot Assembly
It is easiest to clean your pilot light by first carefully removing all logs from your log set. You should then locate the pilot assembly that is attached to your burner. Below are 2 common pilot assemblies
Disconnect HereGas Supply Disconnected
Disconnect the Gas Supply
Once you have located the pilot assembly, you should disconnect the gas supply line from the pilot light itself.
Blow Air Down Pilot in Opposite Direction of Gas Flow
Blow Air Down the Pilot
Once the supply line has been disconnected, you will then use the can of compressed air to blow air down the pilot in the opposite direction of gas flow.
Blow air through the air mixture holes
Blow air through the air mixture holes
Then Blow air through the air mixture holes
Reconnect the Gas Supply and Test for Leaks
You should now tightly reconnect the gas supply line to the pilot light. Using the spray bottle with a soap and water solution, spray the connection. You may now turn the gas shutoff valve to the “ON” position (see above). Watch the connection for a minute or two and make sure that no bubbles form. If any bubbles form, then your connection has a leak and is not secure. Turn the gas shutoff valve off, retighten the connection and again look for bubbles. When there are no leaks, relight your pilot light (see our guide to lighting a pilot light). Once the Pilot light has been relit, you may carefully place the logs back on the burner. If you have Vent-Free or Un-Vented Gas logs make sure to follow the guide in your owner’s manual. Not doing so good cause Carbon Monoxide and soot.